University of Ottawa NMR Facility Web Site

Please feel free to make suggestions for future posts by emailing Glenn Facey.



Friday, April 5, 2013

Removing t1 Noise from Homoonuclear 2D NMR Data - Video Tutorial

The often troublesome stripes of vertical noise in 2D NMR spectra are called t1 noise (i.e. noise originating in the t1 domain). When t1 noise occurs in homoonuclear 2D correlation experiments such as COSY, TOCSYNOESY or ROESY, symmetrization can be used to remove a great deal of the noise and make the data more presentable. The technique was described in a previous post and is demonstrated in this video tutorial using a magnitude COSY spectrum as an example.


Thursday, April 4, 2013

Cable Length and Probe Tuning

NMR probes can be tuned and matched on the bench or while in the magnet using a sweep generator and oscilloscope or a specialized tuning box such as the one available through Morris Instruments.  More typically, probe tuning and matching are monitored using the electronics in the NMR console and preamplifier.  In either case, it is important to realize that any filter or cable between the preamplifier and the probe is part of the rf circuit being tuned and should therefore be present while adjusting the tuning and matching capacitors of the probe.  This is illustrated in the figure below.  An NMR probe was tuned and matched using the wobble function of a Bruker AVANCE spectrometer. There was a bandpass filter and a short cable between the preamplifier and the probe.  The tuning curve is shown in the top of the figure.  The 90° pulse was measured at 11.25 μsec. The short cable was then replaced with a long cable and the probe tuning and matching capacitors were left unchanged.  The tuning curve is shown in the bottom of the figure below.  It is clear that the overall circuit is no longer tuned and matched.  The 90° pulse was measured at 13.75 μsec using the long cable.