Tuesday, March 1, 2011

MAS Rotor Crashes

There is no sound more pleasing to a solids NMR spectroscopist than that of an MAS rotor spinning stably. What happens though when the spinning is abruptly interrupted? This is called a rotor "crash" and when it occurs not only is the pleasing sound replaced by the horrible sound of rushing air, but one often finds damage to both the MAS rotor and the NMR probe. The picture below shows what used to be the solenoid coil of a 4 mm MAS probe after an unfortunate rotor crash. The rotor and sample were reduced to dust. Fortunately in this case the stator was not destroyed.

Here are a few tips to avoid expensive rotor crashes:
1. Spin only as fast as needed for your experiment. Just because your car can go 200 km/h does not mean that it should be driven at 200 km/h. Likewise, just because your probe is rated to spin samples at 15 kHz does not mean that all samples should be spun at 15 kHz.

2. Check the integrity of the rotor and the cap before use. Damaged rotors are weakened and should NEVER be used. Damaged caps can cause instability which may lead to a rotor crash.

3. Make sure the cap fits snugly on the rotor. A cap that lifts or comes off the rotor while spinning will cause a rotor crash.

4. Be aware of sample heating due to spinning. The rotor and sample heat up during spinning due to friction. If the temperature increases such that your sample melts or emits a gas, the rotor may become unbalanced or the cap may be forced off causing a rotor crash.

5. Make sure the rotor is marked properly so the speed can be monitored and regulated. Failure to do this may result in the spin counter receiving a bogus signal and it is possible that the rotor may spin faster than its rated speed causing a crash.

6. Pack your sample evenly to ensure that the rotor is properly balanced during MAS. Rotors that do not spin smoothly and stably should be repacked until they do.

7. Start and stop the rotor gradually to ensure stability while speeding up or slowing down.

5 comments:

Anonymous said...

I had a lot of rotor crashs so far (mainly 2.5mm rotors) but the coil was never damageld so much like seen on the photo. There must have gone a lot of things wrong.

Anonymous said...

And the most important tip?
Don't ever let the rotor fall on the floor!!

spin kid

Anonymous said...

I think the sound of a DOR probe spinning properly is even better!

DB

Glenn Facey said...

Oh yes DB. I agree. Much like the sound of a chord from Bob Dylan's guitar.

Anonymous said...

Or a Boeing 747 taking off!